Browning HP35 Assembly in GunsWorld

	Remove the magazine. Pull back the slide and push the safety catch into the second notch. Push out the slide stop (T-see 'exploded drawing') from right to left, as shown. Release the safety catch and permit the slide to go forward and off the receiver runners.
	Push the safety catch down to fire position, then push sear pin (JJ) out from right to left. Allow the ejector (FF) to pivot down until it stops. With the ejector in this position, the safety catch (KK) can now be pushed out.
	Hold the gun in the left hand and push in the magazine catch (I) until it is flush with frame. Using a 1/8 inch wide screwdriver, turn the magazine catch spring guide to the magazine catch. Then lift out the unit.
	Push trigger pin (GG) out from right to left. Hold the gun with the right side up. With the right hand, pull the trigger forward and upward; this will remove parts (U), (HH), (II), and (OO) as a unit. These parts must be replaced as a unit when reassembling the gun.
	To remove firing pin (F) and spring (E), hold the slide in the left hand. With a 1/8 inch punch, push in the end of the firing pin; at the same time, push down on the firing pin retainer plate (DD). After firing pin and spring have been removed, pry out extractor (D).
	To remove the sear lever (CC), hold the slide upside down in the right hand. Using a small screwdriver, pry up the end of the sear lever retainer (be sure the extractor has been removed before doing this). When the head of the retainer is clear of the slide, pry it the rest of the way from the outside of the slide